Revision as of 07:39, 1 June 2010

This page is dedicated to getting MeeGo running on the Beagleboard. More info on the beagleboard can be found here

Because the processor for the beagleboard C4 is an OMAP3530 and the N900 currently sports a similar processor, it seems wise to start with the ARM page.

Steps

So far we've no image for beagleboard ready. But what works so far:

• Take the n900 rootfs and extract to the rootfs partition of the beagle sdcard setup. You can mount rootfs of N900 from this image on /mnt by:
  1. bunzip meego-n900-open-armv7l-1.0.0.20100525.1-sda.raw.bz2
  2. sudo mount -o loop,offset=16384 meego-n900-open-armv7l-1.0.0.20100525.1-sda.raw /mnt
• Then sync the contents to your SDcard by:
  1. sudo rsync -aHx /mnt/* /media/your_sd_card
• MeeGo Beagleboard kernel and modules contains precompiled uImage and kernel modules (v2.6.34) for Beagleboard. You need copy uImage to /boot partition of your SD card, and modules to /lib/modules directory on your root file system.
• Since we are using rootfs tuned for N900, we can stop starting X by replacing id:5:initdefault: to id:3:initdefault: in /etc/inittab.
• To fine tune above kernel follow these instructions:
  1. Copy meego-beagle-kernel.config from above archieve to your kernel compilation directory as .config
  2. make old_config
  3. Tune kernel options using: make xconfig
  4. You can now compile your kernel using: make uImage