ARM/Snowball

Introduction

• July 2011: Snowball is a powerful board with ST-Ericsson’s Nova A9500 processor (ARM dual-core Cortex A9 @ 1GHz) and the ARM Mali 400 GPU.
• Two versions of the Snowball developer board are sold by Calao Systems and ST-Ericsson's worldwide network of distributors:
  • The software development version (SDK, 4GBytes e-MMC)
  • The product development version (PDK, 8GBytes e-MMC - also usable in end products).
• August, 21st 2011: First minimal boot of MeeGo on a Snowball. Device from MeeGoFI LDP
• August 2011: Nomovok will port MeeGo (with hardfp) on Snowball

Specifications

• • ARM Dual Cortex A9 @ 1GHz
  • 4/8 GByte e-MMC
  • 1 GByte LP-DDR2
  • 1 x Micro-SD
  • 1 x RTC Battery Backup
  • 1 x HDMI Full HD
  • 1 x Ethernet 10/100 Mbits
  • 1 x CVBS Video OUT
  • 1 x Audio OUT
  • 1 x Audio IN
  • 1 x USB OTG Hi-Speed (480 Mbits)
  • 1 x Li-Ion Battery Charger
  • 1 x Serial Port (RS232 / Over USB)
  • 1 x JTAG Connector
  • 1 x MiPi34 Debug Connector
  • 1 x IEEE 802.11 b/g/n WLAN
  • 1 x Bluetooth 2.1 + EDR (Ex.Antenna)
  • 1 x GPS (Ex. Antenna)
  • 1 x 3 Axis Accelerometer
  • 1 x 3 Axis Magnetometer
  • 1 x 3 Axis Gyrometer
  • 1 x Pressure sensor
  • 3 x Expansion Connectors:
    • 1 x 16 pins Top Connector (I2C, SPI, UART, GPIO)
    • 1 x 60 pins Top Connector (I2C, SPI, UART, HSI, FSMC, GPIO)
    • 1 x 120 pins Bottom Connector (LCD, DSI, Camera, CSI, Audio, FSMC)
  • Bootloader: U-Boot (plans are to port Barebox to it for faster boot time)
  • Board Size / Weight: 85 x 85 mm / 62 grs
  • Power Supply: +5VDC via Jack 3.5mm or USB OTG
  • Power Requirement: 250mA Max / Low power mode