Contents 1 Creating a link and adding a repository 1.1 Startpage and Login 1.2 Create a link to a package in your home: 1.2.1 Add link to existing package

Creating a link and adding a repository

Welcome to the MeeGo OBS webinterface guide - part 2. We'll show you how you can login and use the webinterface being hosted at build.meego.com . This includes login, adding a link to a package in your personal workspace (home:) and how to build that package by adding a repository.

Please note: you'll need an account to access the build service server.
See this page on the progress of the Community Builder.

Startpage and Login

Open your favourite browser and navigate to https://build.meego.com. You'll be directed to the startpage.

To proceed, you'll need to login and authenticate with your username and your password. Either enter the data in the upper right corner or click on the login button in the middle.

After successful authentication, you'll end up on the startpage again - with new options visible.

Create a link to a package in your home:

Enter your "Home Project" by clicking on the link on the left side. You'll see this page as setup in part 1:

[[File:|center]] -- add empty home project

Now lets create a link to a package and add a repository to build against. A link is basically a pointer to sources of an already existing package in another project. By repository, we mean a build target - e.g. like Trunk/Fedora_12/openSUSE_11.2 . Lets follow these steps:

1. Add link to the existing package.
2. Add repository / build target.
3. Enable the build (optional, if not already enabled).
4. Observe the build on the monitor page
5. Look at package's page

Add link to existing package

Right below packages, there's "Link Package from other Project" .

[[File:|center]] -- add empty home project, arrow link

Open that page and enter for

Name of original project:
Trunk

and for

Name of package in original project:
bash

- we'll leave "Name of linked package in target project" empty. This is shown on the next picture:

[[File:|center]] -- picture of adding link

Proceed with "Create Link" and you'll be redirected to your home again. You'll see a new package "bash" and a notice about the link being added.

Wonderful, we've added a pointer to the sources - now we need a build target added, so the builder knows the target. To do this, click on "Add Repository". This will look like:

[[File:|center]] -- picture for add repo