Contents 1 mcts-connman-tests 1.1 Setup test environement 1.1.1 Different networks and connect to different networks 1.1.2 Test server configuration 1.2 Run in test machine

mcts-connman-tests

Setup test environement

ConnMan deal with complex network environments. To test ConnMan, we have to setup test environment so that connman test suite can run on. Below diagram shows the ConnMan test environment:

Different networks and connect to different networks

+ Currently there are four networks: Ethernet/WiFi/Bluetooth/3G data networks
+ dhcp enabled networks: All networks should be dhcp enabled so that test machine/server can get IP address. Basically your 3G/Wired network are dhcp enabled. And you need configure your WiFi/Bluetooth networks as dhcp enabled. You can set one of you WiFi AP as dhcp server. And we will discuss how to enable bluetooth server later
+ Test server wire connects to Ethernet and WiFi networks. Test server actually provide Bluetooth PANU service
+ Test machine wire connects to Ethernet. Test machine connects to WiFi/Bluetooth/3G networks through relative technologies

Test server configuration

+ This is one time configuration, and you can use this configuration for all of your connman testing
+ I use ubuntu 10.4 as test server in my environment this time
+ I assume that IP address of test server as 192.168.*.1, please change accordingly
+ Enable broadcast

echo 0 > /proc/sys/net/ipv4/icmp_echo_ignore_broadcast

+ Setup a file for data transfer

mkdir -p /usr/share/mcts-connman-tests
cd  /usr/share/mcts-connman-tests
dd bs=1M count=10 if=/dev/zero of=10M

+ Set up WiFi Aps with

WiFi Open AP : essid: "Guest" and open no security
WiFi WEP/PSK AP with essid and key that you defined.

+ Setup Bluetooth server

# Insert a bluetooth dongle
git clone http://git.gitorious.org/meego-quality-assurance/mcts.git
cp -r mcts/mct-bluez-tests/data/server /usr/local/bin/bluetooth
/usr/local/bin/bluetooth/server_startup.sh &
/usr/local/bin/bluetooth/bt_pan_server_setup.sh &

# Setup dhcp server
# edit /etc/default/dhcp3-server and add following line:
INTERFACES="pan1"

# edit /etc/dhcp3/dhcpd.conf and add following section:
option subnet-mask 255.255.255.0;
option broadcast-address 192.168.0.255;
option routers 192.168.0.1;
option domain-name-servers 192.168.0.1, 192.168.0.2;
option domain-name "connman.org";

subnet 192.168.0.0 netmask 255.255.255.0 {
range 192.168.0.10 192.168.0.200;
}

Run in test machine

testrunner-lite -a -l '-testset=WiFiFeture' -f /usr/share/mcts-connman-tests/tests.xml -o results.xml