Note: This page is work-in-progress (2 November 2010).
NOTE: this page is currently a copy of N900 setup instructions, all instructions on this page should be updated to apply for Aava devices. It is likely that the Qt Creator section on this page is usable as is.
This page instructs in installing the MeeGo image and configuring device access when using Aava device for your development work.
For instructions of installing the MeeGo image on the Aava Moblie(Intel Moorestown platform) using an external Micro SD card, please see the page at http://meego.com/devices/handset/installing-aava-device.
You can use WLAN to connect your Aava device with your computer. USB connection is not enabled yet but will be supported in later update. To use WLAN connection, you need to figure out the IP assigned to Aava device first. so you need to have access to the AP configuration information
To configure device access:
If the message "Could not connect to host" is displayed, check your setting selections and make sure that the network is connected.